Pumps

1.MTD Magnetic

        The Series MTD pump provides the latest enhanced design changes to sealless magnetic drive horizontal centrifugal pumps.

        The MTD incorporates the strongest magnets made from neodymium and are capable of handling specific gravity to 1.8. The use of this strong material assures trouble-free start-up, hydraulically efficient, and continuous duty performance.

        Carbon bushings allow the MTD design to ward off damage from extended dry run conditions where others fail.

2.P Vertical Pump

        Filter Pump’s Penguin Series P pumps are designed to handle a large range of chemicals without difficulty. All wetted parts are constructed of CPVC, polypropylene, or PVDF and have an upper working temperature of up to 280°F.

        The Series P pumps can handle most corrosive, slurries, and abrasive solutions. They are easy to install and operate and are virtually maintenance-free. All pumps have been tested for proper operation before leaving the factory.

3.PHF Vertical Pump

        Filter Pump’s Penguin Series PHF CPVC vertical pumps are simple in design, efficient in performance, and self-priming when immersed in the solution.

        With a double impeller design and no seals to leak or bushings or bearings to wear, this pump can run dry without damage while requiring little or no maintenance.

        Constructed completely of CPVC when in contact with the solution, this pump is suitable for pumping, agitating, filtering, or recirculating acid or alkaline corrosive solutions over the entire 0-14 pH range and feature a maximum temperature of up to 180°F.

4.PS Stainless Steel Vertical Pump

        Filter Pump’s Penguin Series PS 316 stainless steel vertical in-tank pumps are compact and simple in design, having only one moving part, yet highly efficient with proven performance.

        These general corrosion-resistant, all-purpose pumps are ideal for many OEM wet processing applications. Whether you are pumping cleaners, caustics, salt solutions, chlorinated solvents, photographic chemicals, deionized water, fatty, phosphoric, citric, or lactic acids, we can pump it with confidence.

        Maximum temperature ratings are primarily dependent on the elastomer employed and the vapor pressure of the liquid being pumped. Operations temperature range is -30°F to 211°F. Temperatures greater than 211° but less than 250°F are acceptable for non-caustic, non-hydrocarbon service and are primarily dependent on the elastomer employed and the vapor pressure of the liquid being pumped.

        These pumps are designed for in-tank mounting only and have limited dry-run capability.